Muscle Extreme Conditions SL-10™
Muscle Extreme Conditions SL-10™
Heavy-Duty Industrial Lubricant with Corrosion Protection
Extreme Conditions SL-10™ is a heavy-duty lubricant formulated for applications where corrosion prevention is the main concern. It protects exposed metal surfaces from rust and corrosion while displacing water and providing long-lasting lubrication.
Enhanced rust and corrosion protection
Exceptional salt spray protection from a thin-film rust preventive on ferrous metal surfaces
Rapid water displacement
Heavy-duty lubrication
Penetrates into hard-to-reach areas to loosen rusted, seized, and corroded parts
Contains Muscle Metal Treatment MT-10® and Power-Lift Grease PL-10™ for added lubrication
Typical Applications
Power Transmission and Moving Components
Heavy-duty chains
Chain drives
Linkages
Couplings
Bushings
Pulleys
Hinges
Open or externally lubricated bearings
Other exposed moving metal mechanisms
Cable, Wire Rope and Heavy Equipment Applications
Braided steel cable
Wire rope
Dragline equipment, including pins, bushings, and exposed linkage points
Augers
Exposed metal parts
Maintenance and Repair
Rusted nuts and bolts
Seized fasteners
Corroded mechanisms
Hinges and linkages
Tools
Metal assemblies
Corrosion Protection During Indoor Storage
Coiled metal
Stacked metal
Spare parts
Tools and equipment
Fabricated metal parts
Directions for Use
Mix well before use.
Wipe off exposed metal surfaces. Remove any loose dirt, rust scale or debris that can prevent the product from reaching tight areas. Apply Extreme Conditions SL-10™ directly to the area requiring lubrication, corrosion protection, water displacement, or penetrating action.
For general lubrication and corrosion protection, apply enough to coat the metal surface.
For seized, rusted, or corroded mechanisms, apply the product directly to the affected area and allow adequate time for penetration before attempting disassembly.
For storage protection, apply an even film to clean metal surfaces needing protection.
Wipe away excess lubricant with a dry cloth.
Reapply as necessary based on operating conditions, exposure, cleaning, weather, and maintenance intervals.
Always follow equipment manufacturer recommendations where specific lubrication requirements apply.
